Match Pixels in Sketch
I use version 99.5 in this article.
Where
There are three.
- Layers -> Pixel Fitting in Preferences
- Round to Pixel on toolbar
- Below where you put the coordinates.
Each image is pasted below.
Layers -> Pixel Fitting in Preferences
Round to Pixel on toolbar
Below where you put the coordinates.
Subject of Operation
The first important thing is that the object you are operating is which of those
- A shape, such as a square
- A point
A shape, such as a square, is called a layer here.
Operation on Layer
Layers -> Pixel Fitting in Preferences
- When OFF, free state for both movement and deformation
- When ON, it moves with a fixed decimal fraction. ex 4.35 -> 5.35 -> 6.35.
- When ON, the deformation makes the height and width integer numbers.
Round to Pixel on toolbar
The maximum and minimum X-coordinates and maximum and minimum Y-coordinates in the layer are rounded to integers. On the other hand, the other points (so as to maintain their shape?) are not rounded to integers.
Operation on Point
Operation by below where the coordinates are put in
The behavior of dragging and moving points can be set.
From left
- Free
- 1 px
- half px
- quarter px
Round to Pixel on toolbar
The minimum X and Y coordinates of the layer will be used as a reference, and the values will be shifted by an integer from those coordinates. If the minimum X-coordinate of a layer is 4.83, then another point on that layer will result in an X-coordinate of xx.83.
